Serrated Edges for Ribbons Love Finally Tastes Sweet Again

**This mail contains affiliate links to products I use and recommend. I may recieve a small-scale commission, at no price to you, if yous make a purchase through a link.**

Easy spiker bow tutorial with footstep by stride photos. This postal service contains chapter links and we receive a small commission if you make a buy.

My sweet girl is three and a half now. She went through a stage somewhere around the kickoff of terrible ii where she wouldn't allow me put annihilation in her hair. And then terrible twos hit hard and I could barely get a brush through her birds nest of hair. Finally she is coming dorsum effectually to the idea of cute pilus bows. Headbands… forget it! If this sassy lady is willing to wear bows trust me I'chiliad taking reward. Practice you know the feeling?

Last week I ran into Hobby Vestibule for some shop supplies and for once the two babies were behaving and I was able to browse a piddling instead of rushing in and out. I wondered into the ribbon isle where they had 50% off and came across the cutest flamingo grosgrain ribbon. It HAD to come home with me and I knew information technology would brand the cutest bows with Spring and Summertime knocking.

Spiker Bow Tutorial

Supplies Needed:

• 1/2 inch wide ribbon

• ruler

• string (fishing line or thread work too)

• scissors

• lighter

Directions:

ane. Kickoff past cutting your ribbon. I find some of my favorite ribbon on ETSY when I'm looking for fun and unique prints! You will demand (iii) six inch and (ii) 4.5 inch pieces of the 2 inch grosgrain ribbon. Cutting (2) eight inch pieces of the 1/two inch ribbon.

2. Cut a triangle from each of the two inch wide ribbon pieces.

3. Use a lighter to speedily run across the raw edges of the ribbon. This seals the ribbon from fraying.

iv. Pinch the middle of a 6 inch long ribbon peice between your thumb and pointer finger then use your other mitt to fold downward the two ends between your fingers too. Repeat with all 3 6 inch pieces. Secure by tying around the middle with string and knotting. (See the 4 pictures below).

v. Repeat step 4 with the two 4.5 inch long pieces.

6. Place a dab of hot glue on the eye of the bigger ribbon cluster and secure the smaller i to the pinnacle.

vii. Take 1 of the one/2 inch broad pieces of ribbon and hot glue information technology effectually the exterior of a metal prune. You can skip this office just I call back it makes information technology await more polished. Recollect to use the lighter to seal the raw edges of the ribbon.

eight. Take the second piece of 1/2 inch wide ribbon and find the middle. Place a pocket-sized dot of hot glue onto the inside of the clip and and so secure the centre of the ribbon to it.

ix. Put another dab of hot glue onto the bottom of the bow and secure the clip to it. Then wrap the ribbon effectually to the front of the bow and brand a knot.

10. Wrap the ends back around to the back of the bow and place another dab of glue on the inside of the clip and knot again over the mucilage. Clip the ends and seal with the lighter.

Ta-da! Your showtime ane might have a few extra minute just these bows take minutes to brand! You can curl these out like a factory! I clip these right into Delilah'southward hair and they look super beautiful over the acme or under a bun. If your little daughter does clothing headbands y'all could always clip the bow or hot glue it right onto a ring as well. Ready to effort your own!?

More Bow Tutorials

If yous enjoyed this tutorial nosotros accept another boutique bow tutorial you'll honey. Become the stride-by-stride instructions on the DIY boutique bow shown below.

gardnerdret1994.blogspot.com

Source: https://poofycheeks.com/2016/03/spiker-bow-tutorial-with-step-by-step-photos/

Bagikan Artikel ini